Fiat 500 Replacement Key Fob
It may be time to replace the battery if the 500 remote key fob isn't working. If you replace the battery but it isn't working it could be the issue elsewhere.
United Locksmith specializes in the creation of new keys for classic vehicles. We have the tools and parts required for this service.
Dead Coin Battery
A dead battery is the primary cause of your Fiat 500 keyfob not locking or unlocking the doors. The battery inside the key fob will drain quickly when you don't use it frequently enough. If your remote is beginning to show signs of a loss in range or stopped working in the middle of the night, then your battery may be dead.
Metal clips keep the battery in within the key fob. If the clips are loose, it can cause contact issues, which could prevent your remote from receiving power. Use a flathead screwdriver break open the retaining clip and remove the old battery. Make sure you use a replacement battery with the same kind of voltage, the same size, and specification as the original battery.
Water exposure can also cause the key fob to corrode or be damaged. Even a small bath in soapy water may cause damage to the electronic chip inside. Keep your key fob dry.
Water Damage
If your key fob isn't operating properly, it could be caused by water damage. Key fobs are fitted with rubber seals that protect them from being damaged by light rain or splashes of water. However, it is vital to keep your keys out of the ocean, pool, and washing machine!
The key fob has an electronic chip inside that sends a signal to your car's immobilizer system. This is the reason why your 500 can lock or start, but in the event that the chip becomes wet, it will no longer work.
You can try cleaning the internal electronics of your key fob using isopropyl alcohol or an electronic cleaner to determine whether they're still functioning. It is best to replace a key fob in the event that it is submerged in salt water, rather than trying to fix it yourself.
While a replacement fob can cost you a little bit of money, it's much cheaper than paying for your Fiat 500 to be towed to the dealer and repaired! You can also fix it yourself by following a few simple steps. Be sure to have the correct battery type before attempting to open your keyfob. This task is much simpler than it appears and there are step-by-step instructions online for virtually any key fob for your car.
Faulty Chip
The chip located within the key fob communicates with the car's immobiliser unit to ensure the vehicle is only capable of starting when the correct key is used. If the chip is damaged or damaged the car will not start regardless of what you do.
Water damage or a dead battery are the most frequent causes of defective chips. Whatever pop a lock , it's a good idea to leave this task to a locksmith since they can replace the chip fast and at a cost-effective price.
If your key fob does not function after being exposed to water that is clean from the tap or rain take the battery off. Wipe down the electronic component with an old towel. If the key fob still fails to work, it is likely a fried chip and must be replaced.
Some people will go to their dealer when they are in need of a new Fiat key fob, however this can be a very costly alternative. If you're seeking a cost-effective method to get your Fiat key fob fixed Look no further than United Locksmith. We have the equipment and know-how to repair your Fiat fob quickly and professionally. way.
Faulty Receiver Module
Fiat key fobs send signals up 50 feet away to the vehicle, which will open and close the doors (and start the vehicle in case of automatic transmissions). However there are a few factors that could cause the fob to stop working. This could be due to a dead coin battery, water damage, worn buttons as well as a receiver module problem and signal interference or an electronic chip that is malfunctioning.
If the fob was placed in a pocket which has suffered severe trauma (such as being dropped on the floor, or washed in the washer) the fob might not be able to connect with the Body Control Module (BCM) of the vehicle. The BCM is a security system that only accepts signals from genuine original keys.
If this is the case, you will need to replace your fob. A professional locksmith is able to handle all aspects of the replacement procedure, including programming a new one for the 500. They can even offer a clone fob that works the same as the original (and costs one-third of what it would cost).